Skidmore 10MX Series boiler feed units are used to pump condensate and makeup water directly into the boiler(s).  Pumping action is determined by a boiler mounted control which senses boiler water level requriements. 

Skidmore pumps, an integral part of 10MX Series condensate and boiler feed units, provide outstanding benefits due to these important featuers:

• Close coupled, centerifugal design with bronze

  10MX Series Systems
  Capacity - GPM	1 to 18
  Pressures - PSI (3450 RPM)	20 to 40
  Receiver / Steel Rectangular Standard Size in Gallons	10 to 110
  Receiver / Steel Cylindrical Standard Size in Gallons	49 to 1000
  Receiver / Cast Iron Standard Size in Gallons	6 to 110

  enclosed type impeller
• Mechanical seal withstands temperatures to 250 degrees F.  Seal water is recirculated to pump suction to assure adequate lubrication at all times.
• Heavy duty, drip proof, 3450 rpm, 60 Hz motor-designed for continuous duty with pre-lubricated, shielded ball bearings and stainless steel shaft.  Your choice of single phase 115/230 volt with built-in overload protection or three phase 230/460 or 208 volt. T.E.F.C. available upon request.
• Low maintenance, easily serviceable design-any part subject to normal wear is readly available.  Impeller and seal can be serviced without disturbing system piping or electrical connections.

 10MX Series condensate and boiler feed pumps are packaged units, completely assembled, wired, and tested at the manufacturing plant.  They are designed to provide maximum efficiency, reliability, and easy maintenance in a compact, space-saving configuration.  Each unit is factory tested before shipment to assure the product is ready for service when it is received.